industrial repair agent > BD215 wear abrasion resistant repair agent epoxy coatings

BD215 wear abrasion resistant repair agent epoxy coatings

BD215 anti wear abrasion resistant repairing agent ceramic epoxy coating

Product description of our BD215 anti abrasion wear resistant epoxy ceramic coating repair agent:
It’s the high performance wear&corrosion resistant polymerization ceramic materials compounded by various
high performance wear resistant,corrosion resistant material(such as:ceramic,silicon carbide,carborundum, titanium alloy)
and modified toughening heat resistant resin. Used in exactly repairing the friction and wear failure shaft,shaft hole,
bearing block and other parts.

performance index:

product name	physical state	standard packaging	volume (cm3)	operational time limit (25℃)	usable time (25℃)
BD215 abrasion wear resistant epoxy coating repairing agent	paste	500g/set Two-component	325	45min	24h

color	density (g/cm3)	compressive strength (Mpa) GB1041-2008	tensile strength (Mpa) GB6329-2008	shear strength (Mpa) GB7124-2008	bending strength (Mpa) GB1042-1999	hardness （Shore D） ASTM-D-2556	working temperature （℃）
black	1.54	143	57	38	63	93	-60～163

How to use:
1.Surface treatment: Do the coarsening treatment on the pending-repair parts,if the condition is allowed,can grind out a approximately 1.5mm thickness screw thread,then clean it by cleaning agent
and dry it by airing.

Configuration: According to the mass ratio A:B=6:1 or volume ratio A:B=4:1, make A and B two components mix uniformly,
then use it up within specified operation time limit.

Coating: Make the mixed-up material spread coating on the pending-repair areas layer by layer,the first layer should be compacted,make it infiltrate fully with the substrates.If the following working
procedure needs machining,should keep out appropriate machining allowance.

Curing: Cure for 8 hours at the temperature of 25～30 degree before doing machining, cure for 24 hours before putting it into use, if the temperature is below 15 degree,should heat it up or prolong the curing time to promote the curing,generally heat it up to the temperature of 80 degree and
keep this temperature for 2 hours to complete the curing with iodine tungsten lamp or hair dryer.

Packaging specification:
Two-component,500g/set,packed in a common plastic drum,8 sets/carton or 16 sets/carton.

transportation and storage:
Sealed storage in the cool and dry place.The warranty period is 24 months.Avoid placing it upside down,
knocking against and transporting it as a non-dangerous product during transportation.

product packaging photo of BD215 high temperature abrasion resistant repair putty epoxy paste compound:

------分隔线----------------------------